Service Club Membership includes:
(2) Visits per year: (1) one cooling & (1) one heating to perform a precision tune up, a professional cleaning and a thorough safety inspection (Note: Additional visits available upon request with additional charge)

Cooling Visit:

• Check blower housing/wheel for cleanliness
• Clean/Clear condensate drains
• Lubricate condenser fan motor (if required)
• Basic wash of condenser coil for maximum efficiency
• Check refrigerant charge for proper cooling temperatures and pressures (Conventional Air conditioners, air source heat pumps and Geothermal Split system heat pumps)
• Perform equipment temperature and pressure drops and testing on the water loop side (Geothermal equipment)
• Test and adjust loop temperature and pressure drops for maximum heat of rejection/extraction (Geothermal equipment)(Note: When balance valves are available)
• Check indoor blower speeds and CFM to match system sizing
• Tighten and check all wiring connections for safety and corrosion
• Check temperature drop across indoor coil for proper variances per manufacturer specifications
• Clean and polish exterior equipment (Conventional Air conditioners and heat pumps)
• Check safety switches and devices
• Test thermostat for proper operation
• Check for proper compressor & motor amperage per manufacturers specifications
• Inspect and check motor capacitors, contactors and connections
• Inspect duct system for any visual leakage and performance loss
• Replace standard 1” filter as required

Heating Visit:

• Inspect and check heat exchanger for cracks or holes (Gas Furnace equipment)
• Check and adjust incoming gas manifold pressure to meet manufacturer specifications as required(Gas Furnace equipment)
• Lubricate all moving parts and motors (if required)
• Inspect and check vent piping for proper venting and rise (Gas Furnace equipment)
• Check refrigerant charge for proper heating temperatures and pressures (Air source heat pumps and Geothermal Split system heat pumps)
• Perform equipment temperature and pressure drops and testing on the water loop side (Geothermal equipment)
• Test and adjust loop temperature and pressure drops for maximum heat of rejection/extraction (Geothermal equipment) (Note: When balance valves are available)
• Check blower housing/wheel for cleanliness
• Test indoor fan and furnace limit safeties as required
• Check temperature rise across heat exchanger (Gas Furnace equipment)
• Clean and adjust burners for maximum efficiency (Gas Furnace equipment)
• Tighten and check all wiring connections for safety and corrosion
• Test thermostat for proper calibration and heat anticipation setting
• Inspect thermocouple/igniter for proper burn and/or ignition setting (Gas Furnace equipment)
• Check indoor blower speeds and CFM to match system sizing
• Check for proper compressor & motor amperage per manufacturers specifications
• Clean and polish furnace or air handler exterior
• Inspect duct system for any visual leakage and performance loss
• Replace standard 1” filter as required